EMR
HomeGB-4000ResourcesProjectsNewsLinks
Proven Protection from Cell Phone RFs!

Although the cell phone industry continues to claim that their products are safe, there is still no scientific data available to prove this. Evidence to the contrary, however, is increasing every day.

Ferrite Beads that attach easily to cell phone headsets offer real protection against potentially dangerous cell phone radiation.

In essence, your cell phone is a radio. When you talk on your cell phone, your voice is transmitted from the antenna as radio frequency radiation (RFR) between 800 MHz and 1,990Mhz. This frequency falls in the range of microwave radiation and, when you are exposed to it, there is a significant chance you can have serious health consequences.

Depending on how close the cell phone antenna is to your head, between 20% and 60% of the radiation emitted by your cell phone is transferred into your head. The radiation actually penetrates the area around your head and is absorbed, with some radiation reaching an inch, to an inch and a half, into your brain.

Cell phones are designed to transmit radio waves in all directions because base stations can be located in any direction with respect to phone users. This means that portions of the radio waves they produce are directed towards your body.

If you have a cell phone that can work on speakerphone then you already have your solution. You simply need to use your speakerphone. Doing so will greatly decrease your exposure to both EMFs and radio frequencies (RF).

However, using a speaker phone can present a problem if you are in a noisy environment or it just isn't convenient to use. If this is a case, you can use a ferrite bead attached to your headset as another option.

While they do not block EMFs, ferrite beads will effectively knock out your cell phone's radio frequencies, decreasing their tissue-heating effects on your brain.

If you are a regular cell phone user, this simple bit of technology could literally SAVE YOUR LIFE.

Step 1

Open Ferrite Bead and disconnect your headset wire from your cell phone as shown in the figure to the left.

Step 2

Loop headset wire around itself one time, creating a loop large enough to fit over the length of the Ferrite Bead.

Be sure to make the loop close to the end of the wire that plugs into your cell phone.

Step 3

Place looped section of headset wire over one side of the Ferrite Bead.

Be sure to have the section where the looped wire crosses itself against the inside surface of the Ferrite Bead.

Lengthen this crossed section so that each side of the loop, touching the inside of the Ferrite Bead, spans the entire length of the Ferrite Bead.

Step 4

Once the headset wire is properly in place, pull either end so the wire fits snuggly around the Ferrite Bead.

Step 5

Close the Ferrite Bead securely and plug the headset wire back into your phone.

Ferrite diodes can easily attach to cell phone headsets and may offer real protection against potentially dangerous cell phone radiation. Ferrite diodes are common in the electronics and computer industry. For example, look at the cable which connects your computer monitor to your computer and you will see a ferrite diode molded into the cable near one or both ends.

You can order a high quality TDK ferrite bead as shown above
for $18 plus $9 shipping and handling by clicking here.

Copyright © 1996-2005 EMR Labs, LLC. All rights reserved.
Contact | Search Google